Capstone design project · Team 29In progress
Performia
A sled training machine that measures the athlete’s force and adjusts resistance in real time.
- Role
- Team lead and software subsystem owner
- Team
- 7 people
- Stack
- ESP32, FreeRTOS, Manchester, CRC16, ARQ, HX711, Nextion
ESP32 · PHY_TX → PHY_RXReceived intact
- Frame
- 14 bytes
- CRC-16
- 0x4774
- Coding
- Manchester
- useful throughput (calculated)
- ~18kbit/s
- protocol phases
- 5
- tasks on 2 cores
- 5
- team members
- 7
Try it
Send a message through the data link.
Type a word: it becomes a real frame, Manchester-encoded and protected by a CRC-16. “Disturb the line” flips one bit; the CRC catches it and the frame is sent again. The format is simplified; the principle is the one I programmed on ESP32.
01The problem
The machine has to measure the athlete’s force and adjust resistance in real time, while several subsystems exchange data without losing any.
02Architecture
- 01Force sensorsHX711
- 02ESP32FreeRTOS, 5 tasks on 2 cores
- 03Data linkManchester, CRC16, ARQ
- 04TouchscreenNextion, UART
03Decisions
- 1Offload graphics rendering to the Nextion screen so the ESP32, already running the sensors and control loop, is not overloaded.
- 2Five-phase protocol: initialization, continuous flow, fault detection, retransmission and closure.
- 3RMT-based replacement code for the PHY_TX and PHY_RX tasks.
04Challenges solved
- Watchdog crash: bit-banging was starving Core 0.
- Phase misalignment in PHY_RX caused by interrupt latency.
- Wrong preamble: eight zero bits instead of the alternating 0x55 pattern.
05Where it stands
Calculated useful throughput of about 18 kbit/s. The project is still in progress.